Making Cycle More Effective
When it comes to running a cycle of testosterone, you never want to just blindly jump right in. Rather, it is wiser to employ a well thought out plan of attack which will allow you to obtain the right steroids responsibly, run the cycle for the correct length, then wind down the cycle and allow the body to recover. Let's check out such an anabolic steroids guide to making our next cycle more effective.
Plateau first If you haven't been training as a natural bodybuilder for at least three years – and reached something close to your own natural potential – then you have no business resorting to the use of anabolic steroids. You will set a natural ceiling for yourself which will never be overcome. Rather, you should train hard and utilize proper nutrition, and get your body to a place where you cannot advance any further – and only then resort to steroid use!
Plan ahead There's nothing worse (for the bodybuilder using artificial testosterone hormones) than a situation where a cycle (or PCT) is cut short or interrupted because the athlete doesn't have enough gear remaining. Don't begin a cycle until you have everything required to actually finish the cycle. A 7-week cycle gives you most of the negatives – and only a fraction of the positives – of a 12 week cycle. Don't shortcut your progress!
Dose moderately A cycle of 400 to 600 mg of testosterone per week is more than adequate for making solid muscle gains. Beyond that, and the strain you are placing upon your body's systems (in terms of negative side effects) may be too much.
Utilize PCT Arimidex or a similar post-cycle therapy compound is always advisable following a run of testosterone. Your body will not be producing its own testosterone at this point, and any kind of crash will mean you'll see hard earned muscle and strength gains slipping away. Plus you will feel better – there is no worse feeling from going from 400 mg of testosterone injected to zero mg of naturally produced testosterone overnight – ouch!
Take a break Follow any bodybuilding steroid cycle with a break lasting an equal amount of time. No anabolic steroids guide would be complete without such advice. You don't need more steroids after your PCT – you need time to heal and rebuild without gear. Skipping this break will leave your receptors drained, and your next cycle will be less effective as a result!
Do it again! Once you've given yourself about three months to heal, you are ready for your next testosterone cycle! If you used Enanthate last time, opt for Sustanon or Decanoate this time. The varying release times and attack mechanisms can leave your body confused, which is very good for simulating new muscle growth!
Injectable Anabolic Steroid
Active ingredient: Testosterone Enanthate
Manufacturer: Dragon Pharma
Amount: 1 X 10 ml (250 mg/ml)
Lab Tested: View Results
Injectable Anabolic Steroid
Active ingredients:
- 20 mg/ml of Testosterone Acetate
- 30 mg/ml of Testosterone Propionate
- 60 mg/ml of Testosterone Phenylpropionate
- 60 mg/ml of Testosterone Isocaproate
- 100 mg/ml of Testosterone Decanoate
Manufacturer: Dragon Pharma
Amount: 1 X 10 ml (270 mg/ml)
Lab Tested: View Results
Active ingredient: Nandrolone Decanoate
Manufacturer: Dragon Pharma
Amount: 1 X 10 ml (300 mg/ml)
Lab Tested: View Results
There you have it – the anabolic steroids guide for dummies. It's not rocket science, but without well planned strategies and steps, you sure can crash and burn. With the right plan, you may find yourself a star in the bodybuilding universe!
Customers Feedbacks
Please leave your feedback on products or service below.
Thank you beforehand.